Connecting power, Power:connecting, Ensure the power switch on the jukebox is off – HP Surestore 320ex Optical Jukebox User Manual
Page 25: Note use the power cord shipped with the jukebox, Plug the socket end of the power cord into the, Plug the other end of the power cord into a pow, (after the jukebox is moved to its operating lo, Turn the power on, Testing, Note if
Chapter 1
1-13
Setting Up the Jukebox
Connecting Power
Ch
ap
ter
1
: Setti
ng
up
the Disk Driv
e
S
ettin
g u
p
th
e
Ju
kebo
x
Connecting Power
1. Ensure the power switch on the jukebox is OFF (see Figure 1-1).)
NOTE
Use the power cord shipped with the jukebox.
2. Plug the socket end of the power cord into the power port on the bottom of the
interface enclosure (see “8” on Figure 1-2).
3. Plug the other end of the power cord into a power outlet.
4.
(After the jukebox is moved to its operating location) Lower the leveler feet and
tighten the 1/2-inch nut on each foot.
5. Turn the power on.
TESTING
and
NOT READY
alternately display. Once the poweron test
completes (approximately 1.5 minutes),
READY
displays.
NOTE
If
DEVICE FAILED
displays. See “Troubleshooting” in Chapter 3 for
troubleshooting procedures.
NOTE
Go to “Configuring Write Verify” on the next page to complete the installation.