HP Designjet Z2100 Photo Printer series - Manual (Page 139)

5. Select the custom print-quality options in the driver dialog (Mac OS Print dialog), and turn on the
More passes option.
6. Align the printheads. See Align the printheads on page 144 .
The whole image is blurry or grainy
1. Check that the paper type you have loaded corresponds to the paper type selected in the front
panel and in your software. To check on the front panel, use the
View loaded paper key.
2. Check that you are printing on the correct side of the paper.
3. Check that you are using appropriate print-quality settings (see Printing on page 41 ). In some
cases, you can overcome a print-quality problem merely by selecting a higher print-quality level.
For instance, if you have set the Print Quality slider to Speed, try setting it to Quality; if you have
already set it to Quality, try selecting custom options and then More Passes. If you change the
print-quality settings, you may wish to reprint your job at this point in case the problem has been
solved.
4.
Go to the front panel and select the Ink menu icon , then Printhead information to see the
printhead alignment status. If the status is PENDING, you should align the printheads. See Align
the printheads on page 144 . After alignment, you may wish to reprint your job in case the problem
has been solved.
5. Go to the front panel and press the View loaded paper key to see the paper advance calibration
status. If the status is RECOMMENDED, you should perform paper advance calibration: see
Recalibrate the paper advance on page 119 .
If the problem persists despite all the above actions, contact your customer service representative for
further support.
The paper is not flat
If the paper does not lie flat when it comes out of the printer, but has shallow waves in it, you are likely
to see defects in the printed image, such as vertical stripes. This can happen when you use thin paper
that becomes saturated with ink.
ENWW The whole image is blurry or grainy 129
Troubleshooting print-
q
u
ality issues