HP StorageWorks XP Remote Web Console Software User Manual
Page 99
Table 42 ESTPAIR Command Parameters (Resynchronizing Pairs) (continued)
Description
Value
Parameter
CAUTION:
When a Quick Restore operation
or a Reverse Copy operation is required and
if you specify NO for the ONLINSEC
parameter, the job will end abnormally by
reporting CC = 12. If you specify YES for the
ONLINSEC parameter, you may execute the
job. However, note that the copying operation
is performed without any online check.
For a Quick Resync request, set MRF00. This
parameter is valid for MODE(RESYNC) only.
For a Quick Restore request, set MRQ00. This
parameter is valid for MODE(RESYNC) only.
For a Reverse Copy request, set MRR00. This
parameter is valid for MODE (RESYNC) only.
For a Resync request on all pairs in a CTG, set
MAnn0. where nn is the CTG ID. This request
triggers a normal Resync operation.
Secondary volume (T-VOL): SSID, serial
number, and channel connection address.
SEC
Re-establish a split or suspended volume pair.
RESYNC
MODE
Copy speed of resynchronization will be slow,
except when the DKC emulation type is 2105
1
PACE
or 2107. When the DKC emulation type is
2105 or 2107, the copy speed of
resynchronization is always medium regardless
what you specify for the PACE parameter.
Copy speed of resynchronization will be
medium.
other than 1
SIz does not use this parameter. SIz ignores it.
Not applicable.
CRIT
If you specify this parameter when
MODE(RESYNC) is set, the command ends
YES
MSGREQ
NO
abnormally by reporting CC = 12. Do not
specify this parameter when MODE(RESYNC)
is set.
Primary volume CU number, or secondary
volume CU number.
1
LSS
Pair resynchronize operation (forward) will be
performed whether the T-VOL is online or not.
YES
ONLINESEC
2
Pair resynchronize operation (backward) will
be performed whether the S-VOL and T-VOL
are online or not.
Pair resynchronize operation (forward) will not
be performed if the T-VOL is online .
NO
Pair resynchronize operation (backward) will
not be performed when the status of the
volumes are online or offline. The ICKDSF job
ends abnormally (CC = 12).
Although no error occurs when you specify
YES for this parameter, note that the copying
operation is performed without any online
check.
1
CU number or the parameter is valid only for the DKC emulation type 2105 or 2107.
2
When you do not specify the parameter, the result is same as when you specify NO for this parameter.
shows an example of the PPRCOPY ESTPAIR command with the
MODE(RESYNC) parameter.
Resynchronizing Pairs Using PPRC Commands
99