HP StorageWorks XP Remote Web Console Software User Manual
Page 88
7 Performing ShadowImage for Mainframe Pair Operations
Using XP for Business Continuity Manager Software
This chapter provides a brief description for using XP for Business Continuity Manager Software™
to perform ShadowImage for Mainframe pair operations.
•
•
XP for Business Continuity Manager Software ™and PPRC can both be used to perform the same
SIz pair operations. However, since the XP for Business Continuity Manager Software™ and PPRC
are independent functions, do not use them in combination to perform the SIz pair operations.
Command Device for XP for Business Continuity Manager Software
ShadowImage for Mainframe supports XP for Business Continuity Manager Software ™CLI
commands to enable you to perform XP Business Copy pair operations and view XP Business Copy
pair status. For detailed information on using XP for Business Continuity Manager Software™
features, see the user documentation for XP for Business Continuity Manager Software.
To use XP for Business Continuity Manager Software ™CLI commands, you need to assign a volume
as the command device for the XP for Business Continuity Manager Software™ separately from
the command device used for the open system. The volume used as the command device for the
XP for Business Continuity Manager Software ™can only be assigned by employing relevant XP
for Business Continuity Manager Software features. For further information about the command
device, see the HP XP for Business Continuity Manager Software User's Guide.
XP for Business Continuity Manager Software CLI Commands that
Correspond to the PPRC Commands
lists the XP for Business Continuity Manager Software™ CLI commands that
correspond to the PPRC commands that can be used to perform the SIz pair operations.
For further information on the PPRC commands, see
. For further information about the
XP for Business Continuity Manager Software™, see the HP XP for Business Continuity Manager
Software User's Guide.
Table 33 XP for Business Continuity Manager Software CLI Commands Corresponding to the PPRC
Commands
Support Method
(parameter/config)
XP for Business Continuity
Manager Software
Commands
Parameter
PPRC Commands
config
YKMAKE/ YKRESYNC
DEVN
CESTPAIR
config
PRIM
config
SEC
The command used for add
pair operation differs from
MODE
the one used for resync pair
operation.
config (CopyPace)
PACE
Not supported
MSGREQ
88
Performing ShadowImage for Mainframe Pair Operations Using XP for Business Continuity Manager Software