3 using the enclosure monitor manager – HP OneView for Microsoft System Center User Manual
Page 14
3 Using the Enclosure Monitor Manager
IMPORTANT:
•
The Enclosure Monitor Manager is used with version 1.x of the HP BladeSystem Management
Pack for Microsoft System Center to manage enclosures for monitoring. Version 2.x of the HP
BladeSystem Management Pack uses the HP Device Monitor to manage HP BladeSystem
enclosures. If you are using version 2.x, see the HP Device Manager for Microsoft System
Center User Guide for information on managing enclosures. See
for a link to this guide.
•
The Enclosure Monitor Manager only supports the Enclosure Monitor Service included with
the same installation package. If any issues occur that could be caused by incompatible
versions, update the monitor manager and monitor service with the same installation package,
and then verify that you entered the correct IP address or DNS name.
The Enclosure Monitor Manager enables you to easily monitor the health of HP BladeSystem
enclosures. The monitor manager requires user configuration for the Onboard Administrator to
begin monitoring an enclosure. The monitor manager enables you to configure the required
credentials and configuration information.
The monitor manager task appears in the Monitor Service State view when at least one enclosure
is registered.
The Enclosure Monitor Manager interface includes the following fields:
•
Tree pane (left)
This pane, which can be collapsed and expanded, contains a tree that displays the connected
monitor service and enclosures managed by the monitor service. The root node is the HP
BladeSystem Enclosure Monitor Manager. The second level lists the connected Enclosure
Monitor Service. The third level shows enclosures managed by the Enclosure Monitor Service.
14
Using the Enclosure Monitor Manager