HP XP P9000 Auto LUN Software - Manual (Page 46)

Table 25 RAID Manager errors related to manual migration plans (continued)
Required Action Message Error Code
(SSB2)
The volume cannot be migrated. Check the
configuration definition file. The migration target volume is a quorum disk. 203a
The volume cannot be migrated. Check the
configuration definition file. The migration source volume is being used by two
mirrors in a 3DC multi-target configuration, 2045
cascade configuration, or delta resync
configuration with three Continuous Access Journal
sites.
The volume cannot be migrated. Check the
configuration definition file. The migration target volume is being used by two
mirrors in a 3DC multi-target configuration, 2046
cascade configuration, or delta resync
configuration with three Continuous Access Journal
sites.
Specify a volume whose capacity is supported. The current microcode version does not support
the capacity of the migration source volume. 204A
Specify a volume whose capacity is supported. The current microcode version does not support
the capacity of the migration target volume. 204B
Release the volume from Data Retention, and then
migrate the volume. The migration target volume is being used with
Data Retention. 2051
Release the volume from Continuous Access
Journal, and then migrate the volume. The migration target volume is being used with
Continuous Access Journal. 2055
Release the volume from Continuous Access
Journal, and then migrate the volume. The migration source volume is being used with
Continuous Access Journal. 2056
The source volume and target volume cannot
belong to the same parity group. Select a source The migration target volume and the migration
source volume belong to the same parity group. 2058
volume and target volume from different parity
groups.
Wait for the shredding operation to complete and
then migrate the volume. The migration source volume is being shredded. 205A
Release the volume from Continuous Access
Journal, and then migrate the volume. The migration target volume is being used with
Continuous Access Journal. 205C
Perform the following actions for each cause: The migration source volume corresponds to either
of the following causes: 2075
1. Change the Snapshot pair status to PAIR, and
then migrate the volume.
1. The volume is P-VOL of the Snapshot pair. The
pair is not in PAIR status.
2. None. This migration plan cannot be executed.
2. The volume is S-VOL of the Fast Snap or
Snapshot pair, or V-VOL of Fast Snap or
Snapshot.
Perform the following actions for each cause: The migration target volume corresponds to either
of the following causes: 2076
1. Release the Fast Snap or Snapshot pair, and
then migrate the volume.
1. The volume is P-VOL of the Fast Snap or
Snapshot pair.
2. None. This migration plan cannot be executed.
2. The volume is S-VOL of the Fast Snap or
Snapshot pair, or V-VOL of Fast Snap or
Snapshot.
Release the pool-VOL setting of Fast Snap or
Snapshot from the volume, and then migrate the
volume. The migration source volume is the pool-VOL of
Fast Snap or Snapshot. 2078
Release the pool-VOL setting of Fast Snap or
Snapshot from the volume, and then migrate the
volume. The migration target volume is the pool-VOL of
Fast Snap or Snapshot. 2079
46 Using RAID Manager for manual Auto LUN