Shared uplink sets and vlan tagging, Define shared uplink set screen – HP Integrity BL860c i2 Server-Blade User Manual
Page 74
Network management 74
Port X0 indicates the 10Gb port connected through the midplane of horizontally-adjacent VC-Enet
modules.
Ports X7 and X8 connect to the internal link between horizontally-adjacent Flex-10 enabled VC-Enet
modules.
NOTE:
Virtual Connect does not support stacking for FC modules, so each VC-FC module
requires uplink connections to the external FC SAN environment.
For more information on connecting stacking links, and stacking links in a multi-enclosure environment,
see the HP Virtual Connect for c-Class BladeSystem Setup and Installation Guide.
Shared uplink sets and VLAN tagging
A shared uplink set is a way of identifying for Integrity BL8x0c i2 Server Blades uplinks that will carry
multiple networks over the same cable. In this case, each Ethernet packet carries a VLAN tag (IEEE
802.1Q) to identify the specific network to which it belongs. On shared uplinks, the VLAN tags are
added when packets leave the VC-enabled enclosure and are removed when packets enter the enclosure.
The external Ethernet switch and the Virtual Connect Manager must be configured to use the same VLAN
tag identifier (a number between 1 and 4094) for each network on the shared uplink(s).
Virtual Connect places no special restrictions on which VLAN identifiers can be used, so the VLAN IDs
already used for the networks in the data center can be used on these shared uplinks. To configure a
shared uplink set for VLAN tagging, obtain a list of the network names and their VLAN IDs.
A shared uplink set enables multiple ports to be included to support port aggregation and link failover
with a consistent set of VLAN tags.
Because VLAN tags are added or removed when Ethernet packets leave or enter the VC-Enet shared
uplink, the VLAN tags have no relevance after the Ethernet packet enters the enclosure.
IMPORTANT:
If you are deploying a server where VLAN tags will be used (added) on the
server itself, do not connect the server Ethernet port carrying VLAN-tagged traffic to a shared
uplink set.
Identifying an associated network as the native VLAN causes all untagged incoming Ethernet packets to
be placed onto this network. Only one associated network can be designated as the native VLAN. All out-
going Ethernet packets are VLAN tagged.
To enable native VLAN when defining a shared uplink set, select the box under Native. To enable or
disable native VLAN on an existing network, go to the Edit a Shared Uplink Set screen ("
" on page
). Click on the edit icon, and then select or deselect the box under Native.
Define Shared Uplink Set screen
To access this screen, click the Shared Uplink Sets link in the left VC Manager navigation window, and
then click Define Uplink Set, or select Define Uplink Set from the Define pull-down menu.
The Define Shared Uplink Set screen is accessible to all users with network privileges by clicking the
Define a Shared Uplink link from the VC Manager home page or from the Define pull-down menu.