HP Integrity BL860c i2 Server-Blade - Manual (Page 141)

Hardware information screens 141
Column Description
SAN Fabric Name of the SAN Fabric connected to the uplink port
Port Speed Speed setting of the uplink port
Connector Status Status of the uplink port
Connected To MAC address of the device that this port is connected to on the other end.
The device must support LLDP to display this information.
The following table describes the rows within the Server Port Information table in the Bay Summary
Screen. Click Less < to display only the Port, Server Blade, SAN Fabric, Connected To, and Profile
columns. Click More > to display all columns.
Column Description
Port Port number
Server Blade Server blade bay location
SAN Fabric Name of the SAN Fabric connected to this port
Connected To WWN address of the device that this port is connected to on the other end
Profile Server Profiles with connections to this port
HBA Port HBA port number
HBA Port Speed Speed setting of the HBA port
HBA Port Status Status of the HBA port
HBA WWPN Either the World Wide Port Name assigned to the port or the Server
Factory Default, if not assigning WWNs
Module removal and replacement
Beginning with VC v3.00, it is no longer necessary to administratively remove a module if the module is
not in use. If a module is not in use and is physically removed, it is automatically removed from the
domain.
However, if you are removing a module that is in interconnect bay 1 or bay 2 of the primary enclosure,
you must first delete the domain, and then recreate it after the module has been removed.
As a general rule, if a module has been configured and is in use by the domain, this module can only be
replaced with a module of the same type. For example, an HP 1/10Gb-F VC-Enet Module should be
replaced with another HP 1/10Gb-F VC-Enet Module only. However, the following group of modules are
compatible and can be used to replace another module in this list:
• HP 4Gb VC FC module
• HP VC 4Gb module (with enhanced NPIV)
• HP VC 8Gb 20-Port FC module
When replacing a module with a module of another type, do the following:
1. Remove all port assignments.