HP Optical Jukeboxes - Manual (Page 38)

3-4 Chapter 3
Operating the Disk Drive
Loading a Disk Into the Drive
Loading a Disk Into the Drive
Insert the disk gently but firmly into the opening on the front panel, shutter end first,
and with the side you want to access facing up (A or B).
The drive automatically pulls the disk fully into position.
Ejecting a Disk Using the Disk Eject Button
Press the eject button to the right of the disk slot (see “5” on Figure 3-1).
Manually Ejecting Disks With Power Off
The drive does not automatically eject a disk cartridge if a power failure occurs. An
eject tool is shipped with the drive to use for manually ejecting a disk.
Follow these steps to manually remove a disk from the drive:
1. Disconnect all power to the drive.
2. Insert the eject tool into the small round hole in the front panel of the drive (see
“4” on Figure 3-1).
3. Push the eject tool firmly. The disk will eject.
NOTE After ejecting a disk, the drive remains in “eject position” until power is restored. At
that time, the drive automatically resets itself.