HP Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem - Manual (Page 17)

Command line 17
Item Description
MacType (optional) The type of MAC address source to use for assignment. Valid values include "VC-
Defined", "Factory-Default", and "User-Defined".
MacPool (optional) The pre-defined MAC pool to use for address assignment. Valid values include
integers 1-64. This property is only valid if the MacType is set to "VC-Defined". If
not specified, the default pool ID is 1.
MacStart (Required
if MacType is User-
Defined)
The starting MAC address in a custom user-defined range. This property is only
valid if the MacType is set to "User-Defined".
MacEnd (Required if
MacType is User-
Defined)
The ending MAC address in a custom user-defined range. This property is only
valid if the MacType is set to "User-Defined".
WwnType(optional) The type of WWN address source to use for assignment. Valid values include
"VC-Defined", "User Defined", and "Factory-Default".
WwnPool(optional) The pre-defined WWN pool to use for address assignment. Valid values include
integers 1-64. This property is only valid if the WwnType is set to "VC-Defined".
If not specified, the default pool ID is 1.
WwnStart (Required
if WwnType is User-
Defined)
The starting WWN address in a custom user-defined range. This property is only
valid if the WwnType is set to "User-Defined".
WwnEnd (Required if
WwnType is User-
Defined)
The ending WWN address in a custom user-defined range. This property is only
valid if the WwnType is set to "User-Defined".
SingleDense
(optional)
If the imported domain supports double-dense server blades, this property allows
the device bay display format to support the display for single-dense server
blades along with the double-dense server blades. In a double-dense supported
configuration, the default for this property is false, which turns off the display of
single-dense server blades.
Examples
->set domain Name=MyNewDomainName
Changes the name of the Virtual Connect domain
->set domain DomainIp=Enabled
Enables the domain IP address
->set domain DomainIp=Enabled IpAddress=192.168.0.120
SubnetMask=255.255.255.0 Gateway=192.168.0.1
Configures the domain IP address and enables it
->set domain DomainIp=Disabled
Disables the domain IP address and uses DHCP instead
->set domain MacType=VC-Defined MacPool=10
Sets the MAC address source to VC-Defined with a pre-defined range
->set domain MacType=Factory-Default
Sets the MAC address source to use factory default MAC addresses
->set domain MacType=User-Defined MacStart=00-17-A4-77-00-
00 MacEnd=00-17-A4-77-00-FF
Sets the MAC address source to a custom, user-defined address range
->set domain WwnType=VC-Defined WwnPool=5
Sets the WWN address source to VC-Defined with a pre-defined range