HP Integrity NonStop H-Series - Manual (Page 37)

Chapter Five - SCSI Bridge Electronics
Tandem 5142-xSE Rackmount Tape Subsystems User Guide 2 7
5.12.1 Editing the option access key
This configuration item has been factory-configured and is, therefore, not selectable.
Key:7.0E
[288FEA]
*NOT sel
ectable*
Figure 36 Option access key
5.12.2 Configuring the options setting
If your configuration and/or host environment requires unique settings or special
configurations, Tandem Computers can provide assistance and minor firmware configurations
for specific platforms, software or drives through the use of this menu item. This setting is
factory-configured at
00001400 and should never have to be changed by the user. As
described above special situations may require that this setting be changed but it is highly
recommended that user consult Technical Support before changing this setting. Use the
Numeric Entry Method to enter the eight-digit hex value.
Options
00001400
PRESS to
Done
Options
00001400
PRESS to
Alter
Options
00001200
PRESS to
Alter
Figure 37 Options setting
5.12.3 Selecting a Baud rate
Four different baud rates are available for connecting to a serial terminal or terminal
emulator. Other communication parameters are:
No parity, 8 data bits, 1
stop bit and xon/xoff flow control. The three-pin serial connector on the back of
the subsystem allows connection to a PC serial port by using an extension cable. A
communication package such as PRO-COMM (with
xon/xoff enabled) allows you to
upgrade the flash firmware serially. Select a baud rate by using the Pick Entry Method.
BaudRate
9600 bps
PRESS to
Alter
BaudRate
19K2 bps
PRESS to
Done
BaudRate
2400 bps
PRESS to
Scroll
BaudRate
1200 bps
PRESS to
Scroll
Figure 38 Baud rate