HP Integrity NonStop H-Series - Manual (Page 34)

Chapter Five - SCSI Bridge Electronics
Tandem 5142-xSE Rackmount Tape Subsystems User Guide 2 4
5.11 Setup 1 Configuration Display Format Items
Enter
Set-Up 1
PRESS to
Select
SCSI ID:
[00]
PRESS to
Alter
Tape ID:
[00]
*NOT sel
ectable*
Tape
Term: On
*NOT sel
ectable*
Density:
[C0]
PRESS to
Alter
Rwr% 0.5
Ecc: 0.5
PRESS to
Alter
Exit
Set-Up 1
PRESS to
Select
Figure 29 Setup 1 configuration items
5.11.1 Setting the subsystem SCSI ID
SCSI ID:
[00]
PRESS to
Alter SCSI ID:
[01]
PRESS if
Done
SCSI ID:
[01]
PRESS to
Incremnt
Figure 30 Setting the SCSI ID
This configuration menu item sets the host SCSI ID that is used by the host system to select
the subsystem. Enter a value (0-7) using the Numeric Entry Method. Since no two devices
can have the same SCSI ID on the host bus, please consult your computer manual or
system administrator for available SCSI IDs for tape devices.
Note: The ability to set independently the tape drive's SCSI ID and the host subsystem's SCSI
ID is very useful. As you add devices to a system's SCSI bus, you no longer have to
manipulate jumpers or switches on the tape drive. The subsystem ID can be altered from
subsystem's front panel without regard to the actual physical SCSI ID of the drive itself,
making SCSI device additions quick and simple.
5.11.2 Setting the Tape Drive ID
This configuration item has been factory-configured and is, therefore, not selectable.
Tape ID:
[00]
*NOT sel
ectable*
Figure 31 Tape drive ID