HP Surestore 10.100 Tape Library - Manual (Page 167)

Chapter 5 Removing and Replacing Drive Modules 165
Ch
apter 5
Installing a Drive Module
WARNING It is not necessary to power off the library when inserting a
replacement drive module. However, to avoid injury, do not
insert your hand or foreign objects through the empty drive bay
and into the vertical lift assembly area.
1. Hold the drive module with one hand on the drive module handle while
the other hand supports the bottom ( Figure 53 on page 165).
2. Install the drive by inserting the rail at the top of the drive module into the
slot at the top of the drive module opening.
Note Higher force will be required in the last half-inch of insertion to
engage the electrical connection.
Figure 53 Installing a Drive Module