HP Linux Server Management Software - Manual (Page 73)

6. Test the configuration by performing the following steps:
a.
Run /sbin/syslog-ng with the -s or --syntax-only option to verify the syntax
of the /etc/syslog-ng.conf file on Red Hat or /etc/syslog-ng/
syslog-ng.conf
file on SLES. This should be a symbolic link to /etc/
syslog-ng.conf.client on Red Hat or /etc/syslog-ng/
syslog-ng.conf.client on SLES as described above.
b. Start syslog-ng on all cluster members using
# cexec “/etc/init.d/syslog-ng start”
c. If consolidating the local syslogs, use “logger ” and make sure
this message is in the consolidated syslog.log on the log consolidation server. Note
that the logger messages are first sent to the local syslog which forwards them to
syslog-ng. By default, syslogd suppresses duplicate messages. If you issue multiple
logger test messages, make sure each is unique.
3.3.2.3.3 Forwarding ASCII Log Data
The Consolidated Logging Wizard can automatically configure Serviceguard package logs to be
monitored and forwarded as if they were syslog data. These logs are standard ASCII log files.
For manual configurations, setting CLOG_PACKAGE=1, as described in
“Manually Configuring
a Serviceguard Cluster as a Log Forwarding Client” (page 70) , automatically takes care of package
log forwarding.
You can manually configure log consolidation for arbitrary ASCII log files using the following
procedures for:
• Forwarding text logs for consolidation
• Consolidating text logs on the log consolidation server
3.3.2.3.3.1 Forwarding Text Logs for Consolidation
This procedure contains several steps:
1. Make sure the system is configured as a log consolidation client or server. (Check the /etc/
sysconfig/syslog-ng
file: if CLOG_CONFIGURED=1, the system is configured.) If not,
use the Consolidated Logging wizard or the manual configuration methods described in
this document to configure the system for log consolidation.
2. Edit the system’s /etc/rc.config.d.syslog-ng file. For each ASCII log file you plan
to consolidate, do the following:
•
Add an entry to the CLOG_TEXT_LOG[]array, starting at array index 0. The value for
the array entry must be a complete path to the ASCII log file. For example,
CLOG_TEXT_LOG[0]=/var/opt/myapp/myapp.log
CLOG_TEXT_LOG[1]=/var/adm/logs/mylog.log
• By default, as each line of the text log is forwarded to the log consolidator, values for
several parameters are prepended to each record make the record compatible with
syslog record format.
— If the system is part of a Serviceguard cluster, the following values are prepended:
date timestamp hostname clustername_logfilename
— If the system is not part of a Serviceguard cluster, the following values are
prepended: date timestamp hostname hostname_logfilename
This is equivalent to specifying the following: CLOG_TEXT_FORMAT[n]="custom"
For example, assuming the log files myapp.logand mylog.logare not in syslog
format, the original example could have been fully specified as the following:
CLOG_TEXT_LOG[0]=/var/opt/myapp/myapp.log
CLOG_TEXT_FORMAT[0]="custom"
3.3 Log Consolidation Configuration 73