Customize tray 1 operation – HP LaserJet M3027 Multifunction Printer series User Manual
Page 80
4.
Place media into the tray (short-edge in, print-side up). The media should be centered between
the media-width guides and under the tabs on the media-width guides.
5.
Slide the media-width guides inward until they lightly touch the media stack on both sides without
bending it. Make sure that the media fits under the tabs on the media-width guides.
NOTE:
Do not add media to tray 1 while the device is printing. This could cause a jam. Do not close
the front door when the device is printing.
Customize tray 1 operation
The device can be set to print from tray 1 if it is loaded, or to print only from tray 1 if the type of media
that is loaded is specifically requested.
Setting
Explanation
Tray 1 size is set to Any Size
Tray 1 type is set to Any Type
The device usually pulls media from tray 1 first unless it is empty or closed. If you
do not keep media in tray 1 all the time, or if you use tray 1 only to manually feed
media, keep the default settings of the tray 1 size and type. The default settings
for both the tray 1 size and type are Any. You can change size and type settings
for tray 1 by touching the Trays tab under Supplies Status, and then touching
Modify.
Tray 1 size or type is set to anything other
than Any Size or Any Type
The device treats tray 1 like the other trays. Instead of looking for media in tray 1
first, the device pulls media from the tray that matches type and size settings that
are selected in the software.
In the printer driver, you can select media from any tray (including tray 1) by type,
size, or source. To print by type and size of paper, see
.
68
Chapter 4 Media and trays
ENWW