HP Systems Insight Manager - Manual (Page 149)

E Default system tasks
Polling tasks track the health status of systems in associated collections. Hardware status polling must occur
periodically to determine when systems go offline or when hardware degrades. You can customize polling
tasks for specific systems to run at scheduled times. You can also create polling tasks with different collections
to meet your needs.
You can configure polling tasks to take place based on the receipt of an event. Event polling tasks are
associated with event collections. For example, you might set up a hardware status polling task for when
traps are received from a system.
When a polling task is set up to run as the result of a change in an event collection, the polling task is applied
to all systems generating events that match the given collection.
NOTE: HP does not recommend scheduling a polling task based on periodic event collection. The task
would run on the set of systems for each event in the associated collection.
NOTE: If you remove a hardware status polling task, systems continue to be discovered, but the status on
them is not updated. If you remove the Daily System Identification task, you would no longer detect changes
in management on systems.
The following default tasks are available on the View All Scheduled Tasks page:
•
Biweekly Data Collection
•
Daily System Identification
•
Delete Old Noisy Events
•
Delete Events Older Than 90 Days
•
Hardware Status Polling for Non Servers
•
Hardware Status Polling for Servers
•
Hardware Status Polling for Systems No Longer Disabled
•
Initial Data Collection
•
Initial Hardware Status Polling
•
Software Version Status Polling
•
Software Version Status Polling for Systems no Longer Disabled
•
Daily Check Event Configuration
Biweekly Data Collection
Use this task to collect data. This task runs on all systems in the Data Collection List collection. The default
schedule sets the task to run every other Saturday at noon.
Daily System Identification
Use this task to gather information about systems such as networking systems. By default, this task runs once
a day. The information is identified and stored in the database.
•
Single Sign On and STE support on a managed system
•
Type of management protocol on the system (HTTP, SNMP, and WBEM)
•
Type and subtype of system (server, storage, switch, router, and so on)
•
Product name of the system
•
Operating system name and version
•
Web Agents running on the system
•
Web-based software running on the system (for example, printer management software)
•
System associations with management processors (for example, a system and its Remove Insight board)
•
Storage proxies and related storage systems
•
Wake-on-LAN information
Biweekly Data Collection 149