A regulatory compliance and safety, Regulatory compliance, Modifications – HP Cisco MDS 9124e Fabric Switch for BladeSystem c-Class User Manual
Page 37: Cables

Cisco MDS 9124e Fabric Switch for HP c-Class BladeSystem
37
A Regulatory compliance and safety
Regulatory compliance
Federal Communications Commission notice for Class A equipment
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which
case the user will be required to correct the interference at his own expense. The end user of this
product should be aware that any changes or modifications made to this equipment without the
approval of Hewlett-Packard could result in the product not meeting the Class A limits, in which case
the FCC could void the user’s authority to operate the equipment.
Declaration of conformity for products marked with the FCC logo, United
States only
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
For questions regarding your product, visit:
http://www.hp.com
For questions regarding this FCC declaration, contact us by mail or telephone:
Hewlett-Packard Company
P.O. Box 692000, Mailstop 510101
Houston, TX 77269–2000
1–281–514–3333
To identify this product, refer to the part, Regulatory Model Number, or product number found on
the product.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that
are not expressly approved by Hewlett-Packard Company my void the user’s authority to operate the
equipment.
Cables
Connections to this device must be made with shielded cables with metallic RFI/EMI connector
hoods in order to maintain compliance with FCC Rules and Regulations.
- Cisco MDS 9020 Fabric Switch SN6000C Fibre Channel Switch Cisco MDS 9120 Fabric Switch Cisco MDS 9216 Fabric Switch Cisco MDS 9140 Fabric Switch Cisco MDS 9500 Director Switch Cisco MDS 8Gb Fabric Switch for HP BladeSystem c-Class SN8000C Director Switch Cisco MDS 9216i Fabric Switch StoreFabric SN8500C Director Switch Cisco MDS 9134 Fabric Switch C-series Switch Expansion Upgrades Cisco MDS 9222i Multiservice Modular Fabric Switch Cisco MDS 9124 Fabric Switch Cisco Nexus 5000 Converged Network Switches Cisco MDS 9216A Fabric Switch