HP NonStop G-Series User Manual
Page 112
Command Interpreter
HP AutoSYNC User’s Guide—522580-015
8-24
ADD SYNCUSER
the object file name of the BACKUP program to use on the source system when a
file set is synchronized.
If BACKUP is omitted, the default $SYSTEM.SYSnn.BACKUP program is used.
EMSFILEEVENTS | NO EMSFILEEVENTS
specifies that any synchronization error related to a specific file (for example, error
48, error 45, and so on) will be logged in the EMS log.
The EMS message specifies the name of the logfile SLggguuu, the key of the log
record, the SYNCfileset ID, the file error and the filename portion of the file. The
user should then refer to the logfile for details.
The default is NO EMSFILEEVENTS.
EMSS[UPPRESS] | NO EMSS[UPPRESS]
suppresses the generation of a class of EMS events that are considered optional.
Suppressing the optional messages reduces the volume of output sent to the EMS
collector. The types of messages suppressed are the following:
•
Synchronization process START and STOP messages.
•
Messages reporting configuration changes made by the administrator to a file
set or a batch ID.
Events that report failures are never suppressed and are always logged to the
EMS collector.
The option may be disabled to troubleshoot an AutoSYNC problem or to analyze
unusual behavior.
The default is NO EMSSUPPRESS.
MAXPRIORITY priority
the maximum priority at which the ASYSYNC process can run for this user.
If the PRIORITY option specified with
exceeds this MAXPRIORITY value, this value overrides the
SYNCFileset priority.
If this parameter is omitted, the maximum priority is set to the priority of
AUTOSYNC minus 20.
RESTORE
the object file name of the RESTORE program to use on the destination system
when a file set is synchronized.
Usage Note. EMSSUPRESS is also a GLOBAL parameter. You must use the global
parameter setting on the source and destination systems, rather than the SYNCUSER
option, if you wish to suppress optional messages for synchronizations that are done over
TCP/IP.