HP ProLiant SL2x170z G6 Server - Manual (Page 8)

To set up a static IP address, see “Setting up a static IP address from the BIOS Setup Utility” (page
12) .
Configuring user accounts
LO100 supports four accounts types, with varying levels of permissions to view and control features.
For more information on user accounts, see
“User administration” (page 44) . Two accounts are
available by default, one of type administrator and one of type operator.
The administrator account enables the user to execute the full set of CLP commands and change
management processor configuration. The default administrator account user name is admin, and
the default password is admin.
The operator account enables the user to execute common commands and functions but restricts
access to specific functions, such as adding and changing user account information and changing
the configuration of the management processor. HP recommends logging in with the operator
account to perform common functions. The default user name is Operator, and the default password
is Operator.
For more information on how to log in to LO100, see “Logging in to LO100” (page 25) .
Accessing BIOS Setup Utility and using function keys
Throughout the document, the F10 key is listed as the standard method of accessing the BIOS
Setup Utility, saving changes, and exiting the utility. In some cases, the function keys (F keys) might
not pass through the telnet client correctly to the remote system. If this occurs, use the following
ESC key equivalents:
•
F8–ESC+8
•
F10–ESC+0
•
F12–ESC+@
Using the serial port
The server serial port provides basic serial port functionality and serves as an interface to LO100.
You can configure the system serial port for exclusive use with LO100.
CAUTION: After enabling the serial port for use with LO100, legacy serial devices might not
function correctly if attached to the serial port.
You must configure the LO100 serial port hardware parameters to work with your respective serial
port communications software. LO100 serial port configuration is controlled through the BIOS
Setup Utility.
Enabling serial access
1. Power up the server.
2. When POST displays the message, ROM-Based Setup, press the F10 key. If the server has
an administrator password configured, the system prompts you to enter the password. If the
server does not have a password configured, the main screen of the BIOS Setup Utility appears.
3. Press the right arrow (
→) key to navigate to the Advanced menu.
4. Choose one of these options:
NOTE: If you change the Serial Port Assignment, the BMC IP Address resets. The BMC IP
address might not be the same after reboot.
•
On ML110 G6 and DL120 G6 servers:
8 Configuration