HP ProLiant SL2x170z G6 Server User Manual
Page 12
set oemhp_hostname=
where
is the new DNS host name your server will have.
To retrieve a server IP address using the DNS naming feature, use a system connected to the same
network, open a DOS command prompt, and then type nslookup {server name}. (For
example, nslookup {CBQ123456}.)
Depending on your DNS server configuration, it might take up to 45 minutes for the DNS to register
a server name. For more DNS options in LO100, see
“Configuring network settings using a web
.
Setting up a static IP address from the BIOS Setup Utility
By default, LO100 has DHCP enabled and automatically negotiates an IP address. To disable
DHCP and enable a static IP address:
1.
Press the F10 key during POST to enter the BIOS Setup Utility.
2.
Press the right arrow (
→) key to navigate to the Advanced menu.
3.
To set your network BIOS settings, choose one of these options:
•
On ML110 G6 and DL120 G6 servers:
Press the down arrow (
↓) key to scroll to IPMI. Press the Enter key.
a.
b.
Press the down arrow (
↓) key to scroll to the LAN Settings menu. Press the Enter key.
c.
On IP Address Assignment, select Static.
•
On ML150 G6 servers:
Press the down arrow (
↓) key to scroll to IPMI. Press the Enter key.
a.
b.
Press the down arrow (
↓) key to scroll to the end, and then select BMC LAN
Configuration.
c.
On BMC LAN Configuration, select Static.
d.
Press the down arrow (
↓) key to scroll down and enter a valid IP address, subnet
mask, and gateway address (press the Tab key to move between address fields).
•
On DL160 G6, DL160se G6, DL165 G7 DL180 G6, SL160s G6, SL165s G7,SL165s
G7, and SL160z G6 servers:
a.
Press the down arrow (
↓) key to scroll to IPMI. Press the Enter key.
b.
Press the down arrow (
↓) key to scroll to the LAN Configuration menu. Press the Enter
key.
c.
On DHCP IP Source, select Disabled.
d.
Press the down arrow (
↓) key to scroll down and enter a valid IP address, subnet
mask, and gateway address (press the Tab or period (.) key to move between address
fields).
•
On DL170h G6, SL170z G6, SL170s G6, DL170e G6, and SL2x170z G6 servers:
Press the down arrow (
↓) key to scroll to IPMI Configuration. Press the Enter key.
a.
b.
Press the down arrow (
↓) key to scroll to the LAN Configuration menu. Press the Enter
key.
c.
Press the down arrow (
↓) key to scroll to the end, and then select DHCP IP Source.
d.
Select either of the following:
◦
To set BMC NIC to Disabled, press the Enter key.
•
On DL165 G7 and And SL 165 G7 servers:
12
Configuration