HP ProLiant SL2x170z G6 Server - Manual (Page 28)

1. Select the Power Restore Policy by choosing one of the following options:
•
Always power up—Powers on the server immediately after power is supplied.
•
Restore to powered state prior to power loss—Powers on the system if the system was in
the powered on state before a loss of power.
•
Power pushbutton or command required to power on system—Causes the server to wait
for external action before powering on the system.
2. Click Set.
The power restore policy becomes becomes active after a successful BIOS post.
Controlling server power through the CLP
1. Log in to LO100 CLP as described in “Logging in to LO100” (page 25) .
2. Change to the system1 target by entering cd system1.
3. To power on the server, enter start /system1. For example:
/./system1/> start /system1
System1 started.
4. To power off the server, enter stop /system1. For example:
/./system1/> stop /system1
System1 stopped.
The -force option can also be used with the stop command. This option forces the
implementation to stop the target, ignoring any policy that might cause the implementation to
normally not execute the command. In remote management processor implementation, this
process is equivalent to a hard power down.
5. To reset the server, enter reset /system1. For example:
/./system1/> reset
System1 reset.
Monitoring sensors
LO100 provides operating system-independent remote monitoring of the current status of major
sensors of a target server including system temperature, fans, and voltage. You can view the data
for this feature on the Monitoring Sensors Page through a web browser or through the BIOS Setup
Utility.
Viewing sensor data from a web browser
The Monitoring Sensors screen displays a snapshot of the temperature, fans, and voltage sensor
data, including sensor type, name, status, and current reading. To access this page from a web
browser, on the main menu navigation bar, click Monitoring Sensor.
28 Using LO100