HP ProLiant SL2x170z G6 Server User Manual
Page 23
The load command supports usage only with the following options.
◦
-source
— This option must be specified.
◦
(h)elp
— This option appears on the command line. The command ignores all options
and properties except -output (for terse or verbose output). These options are only valid
for this command when the -help option is used.
source
— This option specifies the target from which to transfer the binary
image. The value specified must be a valid URL. The format is //tftpserverip/path/
filename
. This option is required in the command line when the load command is
executed unless -help is used. The file must be an uncompressed firmware image file
that you create using the DOS ROMPAQ utility found on the Lights-Out 100 Firmware
Upgrade Diskette Utility available for download from the HP website at
◦
Specify one of the following:
-oemhpfiletype csr
for loading firmware
–
–
-oemhpfiletype key
for loading a key
–
-oemhpfiletype cer
for loading a certificate
Example:
/./map1/firmware/-> load -s //16.110.181.187/404.bin -oemhpfiletype csr
Firmware download is in progress.
BMC will be automatically reset once image is programmed and validated.
Checking Image 197120
Erasing Memory 2227924
Dnlding/Prgming 4194304
Time elapsed: 53 seconds.
Download Complete.
•
The reset command causes a target to cycle from enabled to disabled and then to enabled
again.
•
The set command assigns a specific value to a property or group of properties. The standard
syntax for the set command is
set property=new value
.
The set command is used to change any changeable property. If the current directory does
not contain the property you want to change, you must specify the target of the property before
entering the property you want to change.
•
The start command causes the system1 target to power on.
•
The stop command causes the system1 target to power off.
•
The version command queries the version of the CLP implementation or other CLP elements.
For example:
/./map1/-> version
Version 1.00
/./map1/-> cd firmware
/./map1/firmware/-> version
Version 1.00
/./map1/firmware/-> show
/./map1/firmware
Targets
Properties
fwversion=0.59
Using CLP
23