Agilent Technologies Multiple Channel Controller 85330A User Manual
Agilent Technologies Hardware
Table of contents
Document Outline
- Title Page
- What You’ll Find in This Manual…
- Warranty
- Service and Support
- Safety and Regulatory Information
- Manufacturers Declaration
- Typeface Conventions
- Contents
- 1. Installation
- 2. Performance Verification
- 3. Operator’s Check
- 4. General Information
- 5. Manual Operation
- In This Chapter
- To Use the Front Panel
- Softkey Map
- To View or Change the 85330’s GPIB Address
- To Close Any Switch in the System (to select a channel)
- To Change the TTL State of AUX 1 or AUX 2
- To View the Most Recent Error Message
- To View the Revision of the Downloaded Driver
- To View Custom Option Number (If Applicable)
- To Manually Send Trigger Pulses
- To Perform Service Functions
- 6. Programming
- In This Chapter
- GPIB Addresses
- Long and Short Command Syntax
- Definition of Terms
- To Choose a Measurement Configuration
- CW Measurement Configuration
- Single Source Multiple-Frequency Configuration
- Dual Source Multiple-Frequency Measurements
- 8530A Control of Sources
- Fast Source Control
- To Use Direct Control
- To Use Run-Time Control Mode
- Setup of the 85330A Multiple Channel Controller
- Event Triggering
- Number of Frequency Points
- Number of Angular Increments (Events)
- List of Switch States
- Switch Settling Time
- TTL Trigger and Ready Timeouts
- Using More than One Controller
- Starting Run-Time Mode
- Run-Time Measurement Sequence
- Run-Time Measurement Sequence for Multiple Controllers
- Using IMM vs. TTL Trigger for Source 1
- Programming Examples
- 85330A Error Messages
- 7. Remote Programming Command Reference
- Command Syntax
- Common Commands
- *CLS
- *IDN?
- *OPC?
- *RST
- Standard Command Reference
- ROUTe
- ROUTe:CLOSe
- ROUTe:CONTrol
- ROUTe:DELay
- RUNTime
- RUNTime:CONTroller
- RUNTime:EVENt:COUNt
- RUNTime:EVENt:TRIGger
- RUNTime:INITiate:IMM
- RUNTime:SOURce:COUNt
- RUNTime:SOURce:SOURCE1:TRIGger
- RUNTime:SOURce:SOURCE2:TRIGger
- RUNTime:SWITch:DELay
- RUNTime:SWITch:SCAN
- RUNTime:SWITch:TRIGger
- RUNTime:TIMEout:EVENt
- RUNTime:TIMEout:RECeiver
- RUNTime:TIMEout:REMote
- RUNTime:TIMEout:SOURce
- SYSTem
- SYSTem:ERRor?
- 8. In Case of Difficulty
- 9. Service
- 10. Accessory Documentation
- Glossary
- Index