Verifying remote ports 1 and 2, Jumpers, Verifying remote ports 1 and 2 -15 – Agilent Technologies Multiple Channel Controller 85330A User Manual
Page 45: Jumpers -15
85330A Multiple Channel Controller
2-15
Performance Verification
Verifying Remote Ports 1 and 2
Verifying Remote Ports 1 and 2
Equipment Required
•
Jumper (see below)
•
Soldering iron
•
2 jumper wires
Jumpers
shows the jumper assembly that can be used to verify remote port
1 and remote port 2. Using Agilent part number 1251-8863, solder one wire
from pin 6 to pin 8, and another wire from pin 7 to pin 9. A connector hood
is recommended for the 9-pin connector, such as L-com (part number
SDC9AG) (http://www.L-com.com).
Figure 2-6
Jumper Assembly
See also other documents in the category Agilent Technologies Hardware:
- HP 16500B (38 pages)
- E4400-60230 (18 pages)
- Option H48 Multiport Test Set Z5623A (138 pages)
- hard disk drive kit e5052-90202 (13 pages)
- FIXTURE U7242A (10 pages)
- FS2010 (36 pages)
- USB/GPIB Interface Converter 82357A (70 pages)
- 34399A RS-232 (3 pages)
- 1100 Series (28 pages)
- N9340A (161 pages)
- HSSI WanProbe J3916A (179 pages)
- 37907A (16 pages)
- N1022A (24 pages)
- Agilent E6474A (184 pages)
- 82357B (34 pages)
- Agilent E1345A (5 pages)
- 85225F (148 pages)
- 8510C (16 pages)
- Wireless Network Optimization Platform E6474A (194 pages)
- J3919A (189 pages)
- AGILENT U2761A (123 pages)
- 85032B/E 50 (55 pages)
- 8510 (32 pages)
- J6800A (16 pages)
- E6474A (14 pages)
- N2610A (248 pages)
- N6314A (7 pages)
- 85107B (20 pages)
- 8753ET (28 pages)
- N9360A (44 pages)
- Agilent 82350B (51 pages)
- Agilent 4396B (124 pages)
- LXI (8 pages)
- E1439 (246 pages)
- U2802A (67 pages)
- Agilent Hard Disk Drive Kit E5071BU (12 pages)
- U2781A (47 pages)
- E1301B (244 pages)
- E6701A (32 pages)
- N2620A (279 pages)
- E5810A (159 pages)
- E5805A (47 pages)