Agilent Technologies Multiple Channel Controller 85330A - Manual (Page 77)

85330A Multiple Channel Controller 6-3
Programming
To Choose a Measurement Configuration
To Choose a Measurement Configuration
The measurement configuration you use depends on the type of
measurement (CW or multiple-frequency) and the type of system
(one-source or two-source system). One-source systems use the Agilent
8511A/B frequency converter, two-source systems use the Agilent 85309A
frequency converter.
Refer to Figure 6-1 .
How to Use the Figure
Follow the flow chart from the top. Determine if your measurements are
made with a single frequency (CW) or multiple frequencies. Proceed down
the appropriate flow chart path. Proceed in this way until you get to a box
that mentions one of the following headings:
•
CW Measurement Configuration
•
Single Source Multiple-Frequency Configuration
•
8530A Control of Sources
•
Fast Source Control
Proceed to the section indicated to read about that specific configuration.
Figure 6-1 Flow Chart for Finding the Correct Configuration