Agilent Technologies Multiple Channel Controller 85330A - Manual (Page 78)

6-4 85330A Multiple Channel Controller
Programming
CW Measurement Configuration
CW Measurement Configuration
Description In single-frequency measurements, the Fast Source Control mode is not
used. The RF source (and LO source, if used) can either be controlled by:
•
The 8530A (set the sources to Analyzer Language mode), or...
•
The system computer (set the sources to SCPI Language mode).
Refer to the programming “Example 1” on page 6-21 .
To Use this
Configuration The proper setup is shown in Figure 1-2 on page 1-4 . Use the 8530A Fast
Autoranging Data Mode (GPIB command: FASAD ), explained in Chapter 8 of
the Agilent 8530A User’s Guide.