Asante Technologies 35160 - Manual (Page 72)

72
Appendix B. Features and Specifications
The sections below list the features and product specifications for the IntraCore 35160 Series Gigabit
Ethernet switches.
B.1 Features
The following is a summary of the management features of 35160 Series Gigabit Ethernet Switch:
Graphical User Interface: HTML browser-based with password protection for local and remote
management
Command Line Interface: Menu-driven telnet or in-band (via front panel console port)
Front Panel:
Graphical representation of unit with real-time network status
General Information: Software version, dual firmware banks. Admin, system and bootstrap info. Switch
address and system clock
Statistics: User-configurable graph types (bar chart, line chart, table) and counters (since
up, rate, since reset) for RX/TX/Error for each port and unit. Table view also
shows current, peak average and total packets for each port
Port Configuration: State (forwarding, blocking), status (enabled, disabled), link status (up, down)
and mode (speed, duplex), auto negotiation, flow control, priority and security.
Detailed statistics include TX counters (total frames, total bytes, dropped
frames), RX counters (total frames, total bytes, unicast, non-unicast), frame
counters (multicast, broadcast, by packet sizes), collisions and errors
(undersized, oversized, CRC/alignment, fragments, FCS, late events, total)
Spanning Tree: IEEE 802.1D supported
IEEE 802.1S (Spanning Tree per VLAN) future support
IEEE802.1 W (Rapid Spanning Trees) future support
SNMP: Separate read and write communities, and trap authentication. Four configurable
trap receivers (IP address and community)
Address Table: Per-port counts for Mac and IP addresses. Integrated utilities to sort or search for
specific IP/MAC address. Address table shows unit, port, entry (dynamic, static
or multiple), IP address, MAC address and VID
VLAN: Configurable PVID, frame type and ingress filtering
RMON: Embedded remote monitoring supports four groups (history, statistics, alarms
and events)
Port Security: Station move detection and duplicate IP address detection with one (1) trusted
address per port
Supported OS: Windows 95/98/Me/NT/2000/XP, Mac OS 9 and higher, and Linux
B.2 Specifications
Connectors:
Gigabit Ethernet with Auto-Uplink ™ (10/100/1000BaseTX): RJ-45 or GBIC holder
for GBIC transceiver module
Console: Serial (RS-232): DB9
Status Indicators: Separate link-activity, speed (10/100/Gigabit) and duplex (full or half) LEDs for
each port; system power, emergency backup power
Physical Characteristics
Dimensions:
IC35160-T: 17.5 x 10.0 x 1.8 inches (390 x 220 x 39 mm)
IC35160-G: 17.5 x 10.0 x 2.7 inches (390 x 220 x 58 mm)
Mounting: Install into a standard 19-inch rack (1 RU height) or placed on a desktop;
rackmount kit and rubber feet included
Environmental Range: