Asante Technologies 35160 - Manual (Page 40)

40
IntraCore 35160-T Spanning Tree Configuration Menu
STP Status: Enabled
Bridge ID: 8000 00:00:94:BF:00:46
Designated Root: 4000 00:00:94:AA:64:31
Root Port: Port: 3
Root Path Cost: 10
Addr Ageout Time: 300
Hello Time: 2 Sec. Bridge Hello Time: 2 Sec.
Maximum Age: 10 Sec. Bridge Maximum Age: 20 Sec.
Forward Delay: 7 Sec. Bridge Forward Delay: 15 Sec.
t Toggle STP Enable/Disable
i Set Bridge Priority
h Set Bridge Hello Time
a Set Bridge Maximum Age
d Set Bridge Forward Delay
p Spanning Tree Port Configuration
q Return to previous menu
Command>
4.1.3 Spanning Tree Port Configuration
To set the Port Priority and Port Path Cost values for STP, access the Spanning Tree Port Configuration
Menu shown below by typing p in the Spanning Tree Configuration Menu.
IntraCore 35160-T Spanning Tree Port Configuration Menu Port: [01]
Port Name:
Port Speed: 100 Mbps
Port Status: Enabled
Port State: Forwarding
Port MAC Address: 00:00:94:BF:00:46
Port Priority: 0x80
Port Path Cost: 10
i Set Port Priority
c Set Port Path Cost
q Return to previous menu
Command>
S)elect port N)ext port P)rev port
Setting Port Priority and Path Cost
Use the following procedure to set the STP Port Priority and Path Cost values:
1. Access the Spanning Tree Port Configuration Menu by typing p in the Spanning Tree Configuration
Menu.
2. Use the s, n and p commands to select the port you want to configure.
3. Type i to set the Port Priority.
Type c to set the Port Path Cost.
4. Enter a value for the setting you are making. See Chapter 7 for more information.
5. Press
Enter.
The new Port Priority or Port Path Cost is displayed in the Spanning Tree Port Configuration Menu.