Asante Technologies 35160 - Manual (Page 25)

25
IntraCore 35160-T Basic Port Configuration Menu Unit Type: [IntraCore 35160]
Port: [01] Port Name:
1 8 9 16
======== ========
Operating Status: -------- +---+---
Auto Negotiation: ******** ********
Speed/Duplex: GGGGGGGG HGGGFGGG
Port Status: Enabled Link Status: Down
Auto-Nego: Enabled Link Speed: N/A
h Help for Legends
t Toggle Port Status Enable/Disable
v Advanced Port Configuration
g Global Port Configuration
q Return to previous menu
Command>
S)elect port N)ext port P)rev port
To see legends explaining the symbols used for both the Basic and Global Port Configuration Menu settings,
type h. A screen appears, as shown below.
Legends for port status: Legends for port speed & duplex:
X - Absent f - 10 Mbps & full duplex
- - Link down F - 100 Mbps & full duplex
D - Disabled by Mgmt Action h - 10 Mbps & half duplex
d - Disabled by Security Violation H - 100 Mbps & half duplex
B - Blocking G - 1 Gbps & full duplex
S - Listening
R - Learning Legends for port priority:
+ - Forwarding (The range is from 0 to 7)
M - Mirror Port 0 - priority 0 (lowest)
Legends for Enable/Disable State: 1 - priority 1
- - Disabled 2 - priority 2
* - Enabled 3 - priority 3
4 - priority 4
Legends for Auto-Negotiation Advertisement: 5 - priority 5
A - 100Base-TX full duplex mode 6 - priority 6
B - 100Base-TX half duplex mode 7 - priority 7 (highest)
C - 10Base-T full duplex mode
D - 10Base-T half duplex mode
Press any key to continue...
3.7.1 Enabling or Disabling a Port
The enabling or disabling of a port is a manual operation that can be used to isolate a network device that
might be causing problems on the network, or to prevent unauthorized use of a port or station.
To enable or disable a port, use the following procedure:
1. Access the Basic Port Configuration Menu by typing p in the Configuration Menu.
2. To select the port you want to enable or disable, type s, n, or p in the Basic Port Configuration
Menu.
3. To toggle the port’s connection to either enabled or disabled status, type t.
The port’s status is changed immediately, and it is reflected in the Port Configuration Menu’s Port Status
indication and the Operating Status symbol for the port.