AudioCodes MEDIAPACK VERSION 6.2 - Manual (Page 44)

SIP Release Notes 44 Document #: LTRT-26901
CPE SIP Products
33. Enhanced ISDN BRI Support:
Product
MP-11x MP-124
Mediant 600 Mediant 1000
Mediant 800 MSBG Mediant 1000 MSBG
Mediant 2000
Mediant 3000/TP-6310 Mediant 3000 HA/TP-6310
Mediant 3000/TP-8410 Mediant 3000 HA/TP-8410
Management Protocol
Web INI SNMP EMS CLI
This feature provides enhanced support for Integrated Services Digital Network (ISDN)
Basic Rate Interface (BRI) phones connected to the device. This feature enables the
device to route IP-to-Tel calls (including voice and fax) to specific BRI ports (channels).
This is achieved by the following configuration elements:
• New ISDN Supplementary Services table (ISDNSuppServ parameter): This table
allows you to define BRI phone extension numbers per BRI port pertaining to a
specific BRI module. Therefore, this offers support for point-to-multipoint
configuration of several phone numbers per BRI channel. Up to eight phone
numbers can be defined per BRI trunk. In addition, for each BRI endpoint, the
following optional configurations can be defined:
♦ User ID and password - for registering the BRI endpoint to a third-party
softswitch for authentication and/or billing
♦ Caller ID name - for displaying the BRI endpoint’s caller ID to a dialed
destination, if enabled (i.e., “Presentation” is not restricted)
♦ Caller ID presentation/restriction
♦ Enable/disable sending caller ID to BRI phone
• Existing Channel Select Mode (ChannelSelectMode parameter): The new option,
“Select Trunk by ISDN Supplementary Services Table” (10) in the Trunk Group
Settings table (TrunkGroupSettings parameter), allows the routing of IP-to-Tel
calls to specific BRI channels according to the settings in the ISDN
Supplementary Services table.
34. Registration Status Display for BRI Endpoints:
Product
MP-11x MP-124
Mediant 600 Mediant 1000
Mediant 800 MSBG Mediant 1000 MSBG
Mediant 2000
Mediant 3000/TP-6310 Mediant 3000 HA/TP-6310
Mediant 3000/TP-8410 Mediant 3000 HA/TP-8410
Management Protocol
Web INI SNMP EMS CLI
This feature provides support for displaying the registration status of BRI endpoints in
the Web interface. This information is displayed in the Registration Status page
(Status & Diagnostics tab > VoIP Status menu > Registration Status).