AudioCodes MEDIAPACK VERSION 6.2 - Manual (Page 100)

SIP Release Notes 100 Document #: LTRT-26901
CPE SIP Products
Parameter Description
[StaticRouteTable] This ini file table parameter configures the IP Routing table for
defining static IP routing rules. These rules can be associated
with IP interfaces defined in the Multiple Interface table. The
routing decision is thus based on the source subnet/VLAN. If not
associated with an IP interface, the static IP rule is based on
destination IP address.
The format of this table is as follows:
[ StaticRouteTable ]
FORMAT StaticRouteTable_Index =
StaticRouteTable_InterfaceName, StaticRouteTable_Destination,
StaticRouteTable_PrefixLength, StaticRouteTable_Gateway,
StaticRouteTable_Description;
[ \StaticRouteTable ]
Where:
InterfaceName = IP network interface associated with this
routing rule (index of the network interface as defined in the
Multiple Interface table)
Destination = IP address of the destination host/network
PrefixLength = Subnet mask of the destination host/network
Gateway = IP address of the router (next hop) to which the
packets are sent if their destination matches the rules in the
adjacent columns
Description = Arbitrary description of this rule
Syslog Facility Number
[SyslogFacility]
Facility level (0 through 7) for the device’s Syslog messages,
according to RFC 3164. This allows the user to identify Syslog
messages generated by the device.
This is useful, for example, if you collect the device’s and other
equipments’ Syslog messages, at one single server. The
device’s Syslog messages can easily be identified and
distinguished from other Syslog messages by its Facility level.
Therefore, in addition to filtering Syslog messages according to
IP address, the messages can be filtered according to Facility
level.
16 - local use 0 (local0) - default
17 - local use 1 (local1)
18 - local use 2 (local2)
19 - local use 3 (local3)
20 - local use 4 (local4)
21 - local use 5 (local5)
22 - local use 6 (local6)
23 - local use 7 (local7)