AudioCodes MEDIAPACK VERSION 6.2 - Manual (Page 21)

Version 6.2 21 December 2010
SIP Release Notes 1. What's New in Release 6.2
5. Transcoding Mode for SBC and IP-to-IP Applications:
Product
MP-11x MP-124
Mediant 600 Mediant 1000
Mediant 800 MSBG Mediant 1000 MSBG
Mediant 2000
Mediant 3000/TP-6310 Mediant 3000 HA/TP-6310
Mediant 3000/TP-8410 Mediant 3000 HA/TP-8410
Management Protocol
Web INI SNMP EMS CLI
This feature allows separate transcoding mode configuration for the SBC and IP-to-IP
applications. This is important as the required DSP resources for transcoding between
these applications differ. Typically, SBC uses less resources than the IP-to-IP
application, which generally requires two DSP’s. Therefore, two different parameters
with the same options exist for configuring transcoding mode for these applications:
• TranscodingMode: used for the SBC application (the default–“Only if Required”–is
to not use resources)
• IP2IPTranscodingMode: used for the IP-to-IP application (the default–“Force”–is
to use full transcoding resources)
6. Proxy Redundancy Mode per Proxy Set:
Product
MP-11x MP-124
Mediant 600 Mediant 1000
Mediant 800 MSBG Mediant 1000 MSBG
Mediant 2000
Mediant 3000/TP-6310 Mediant 3000 HA/TP-6310
Mediant 3000/TP-8410 Mediant 3000 HA/TP-8410
Management Protocol
Web INI SNMP EMS CLI
This feature allows the configuration of the Proxy Redundancy mode per Proxy Set.
Until now, the Proxy Redundancy mode could be configured only for the entire device
(using the existing “global” ProxyRedundancyMode parameter). This feature is
configured using the new parameter, ProxyRedundancyMode in the Proxy Set table
(ProxySet parameter):
• Not configured - the “global” parameter ProxyRedundancyMode applies (default).
• Parking - the device continues operating with a redundant (now active) Proxy until
the next failure, after which it operates with the next redundant Proxy.
• Homing - the device always attempts to operate with the primary Proxy server
(i.e., returns to the primary Proxy whenever available).
Note that if this parameter is configured, then the global parameter is ignored.