Aiwa XH-A1000 - Manual (Page 30)

ENGLISH
29
En
CLOCK AND TIMER
SETTING THE CLOCK
When the clock is set, the “:” between the hours and minutes
flashes. When the clock setting is canceled due to a power failure,
the entire clock display flashes.
1 Press CLOCK.
2 Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
Turning MULTI JOG changes both the hour and the minute.
f or g is also available instead of MULTI JOG. Holding
these buttons down will vary the time rapidly.
3 Press ENTER or a .
The clock starts from 00 seconds.
To view the clock when another display is in the display
Press CLOCK. The time is displayed for 4 seconds and then the
original display reappears. However, the clock cannot be
displayed during recording.
To switch to the 24-hour standard
Press CLOCK and then press s within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
In the 12-hour standard, "AM12:00" indicates midnight and
"PM12:00" indicates noon.
If the clock display flashes
If the display flashes when the clock is displayed, it indicates
that the clock has stopped due to a power failure or the
removal of the power cord. The current time needs to be reset.
NOTE
If the power-economizing mode (page 10) is on, all the display
lights turn off when the power is turned off. To view the clock,
press CLOCK so that the time is displayed for 4 seconds.
SETTING THE SLEEP TIMER
The unit can be turned off automatically at a specified time.
1 Press SLEEP on the remote control.
2 Within 4 seconds, turn MULTI JOG or press f
or g to specify the time until the power is
turned off.
The time changes between 5 and 240 minutes in 5-minute
steps.
To check the time remaining until the power turns off
Press SLEEP once. The remaining time is displayed for 4
seconds.
To cancel the sleep timer
Press SLEEP twice so that “SLEEPoFF” appears.
Specified time
s
a
MULTI
JOG
ENTER
CLOCK
a
CLOCK
f , g
f , g
MULTI
JOG
SLEEP
f , g
f , g
SLEEP
KARAKE
CLOCK AND TIMER