Canon Macro Ring Lite MR-14EX II - Manual (Page 22)

20
When you set the camera’s shooting mode to (Program AE) or a
fully automatic mode, you can shoot in the E-TTL II/E-TTL fully
automatic flash mode.
1 Set the flash mode to <
a>.
Press the < E> button and set to
< a>.
Check that < M> is not
displayed.
2 Focus on the subject.
Press the shutter button halfway to
focus.
X
The shutter speed and aperture are
displayed in the viewfinder.
Check that < Q> is lit in the viewfinder.
3 Take the picture.
When you press the shutter button
completely, the flash will fire and the
picture will be taken.
X If a standard flash exposure was
obtained, the flash exposure
confirmation lamp lights for 3 sec.
Fully Automatic Flash Shooting
Even when attached to a camera that supports the E-TTL II autoflash,
<
a> is displayed on the LCD panel.
If the flash exposure confirmation lamp does not light or if the subject is
dark (underexposed) when you check the image on the camera’s LCD
monitor, move closer to the subject and shoot again. You can also set a
higher ISO speed when using a digital camera.
“Fully automatic mode” refers to , < 1>, and shooting
modes.
COP
Y