P.1-27), Caution – Brother ULT2001 2001N 2001C 2002D 2003D User Manual

Page 38

background image

Setting Up

1-27

1

2

3

1

2

2

1

1

7. Use both hands to set the thread around projection in

the thread guides.
1

Projection in the thread guides

8. Pass the thread around the thread guide shaft and the

pretension disk as indicated on drawing. Make sure
that thread is correctly inserted inside the pretension
disk.
1

Thread guide shaft

2

Pretension disk

9. Wind the thread clockwise around the bobbin 4-5 times

(as shown in the illustration).

10.Pass the end of the thread through the guide slit in the

bobbin winder seat, and pull the thread to the right.
The cutter will cut the thread.
1

Guide slit

2

Bobbin winder seat

CAUTION

Be sure to follow the process described. If the
thread is not cut with the cutter, and the bobbin
is wound, when the thread runs low it may tangle
around the bobbin and cause the needle to break.