Bobbin winding/lower threading -25, P.1-25, 1-33), Caution – Brother ULT2001 2001N 2001C 2002D 2003D User Manual
Page 36
Setting Up
1-25
1
2
3
Bobbin Winding/Lower Threading
1. Turn on the main power switch.
2. Align the groove in the bobbin with the spring on the
bobbin winder shaft, and set the bobbin on the shaft.
1
Groove of the bobbin
2
Spring on the shaft
CAUTION
Use only bobbins recommended by the manufacturer of this machine (see page 1-8).
Using other bobbins may result in damage or injury.
3. Pivot the spool pin so that it angles toward the front of
the machine. Set the thread spool on the spool pin so
that the thread unrolls from the front of the spool.
4. Push the spool cap on the spool pin as far as possible,
then return the spool pin to its original position.
1
Spool pin
2
Spool cap
3
Thread spool
CAUTION
• If the thread spool and/or spool cap are set
incorrectly, the thread may tangle on the spool
pin and cause the needle to break.
• Use the spool cap (large, medium, or small)
that is closest in size to the thread spool. If a
spool cap smaller than the thread spool is used,
the thread may become caught in the slit on
the edge the spool and cause the needle to
break.
1
2
Press
➜
➜
➜
in that order to display a video example of bobbin
winding on the LCD (see page 1-22). Follow the steps explained below to complete the operation.
1
2
3
4
5
6
7
9,10
11
o
l
8