Brother ULT2001 2001N 2001C 2002D 2003D - Manual (Page 18)

Setting Up 1-7
1 —
2 —
3 —
4 —
5 —
6 —
7 —
8 —
?!
9 —
CONTENTS
Index
1
2
6
■ Knee Lifter
You can use the knee lifter to raise and lower the presser
foot without using your hands, so it is convenient for quilt-
ing and other similar projects.
To attach, angle the knee lifter about 20 degrees to the left
and insert it into the mounting slot as far as possible.
CAUTION
If the knee lifter is not pushed into the mounting slot as
far as possible, it may come out during use.
Use your knee to move the knee lifter to the right in order
to raise the presser foot. Release to the left for the presser
foot to lower.
CAUTION
Be sure to keep your knee away from the knee
lifter during sewing. If the machine is operated
while the knee lifter is pushed, the needle may
break or the thread tension may loosen.
■ Foot Controller
CAUTION
Do not allow fabric pieces and dust to collect in
the foot controller. Doing so could cause a fire or
an electric shock.
1. With the machine turned off, insert the foot controller
plug into its jack on the machine.
1
Foot controller
2 Foot controller jack
2. Switch on the machine, then slowly depress the foot
controller to start sewing.
* The speed set using the sewing speed controller is the
foot controller’s maximum sewing speed.
3. Release the foot controller to stop this machine.
* When the foot controller is being used, the “Start/Stop”
button has no effect on the sewing.
* The foot controller can not be used when the embroi-
dery unit is attached.
Press the “Start/Stop” button.
Note (For U.S.A. only)
Foot controller: Model P
This foot controller can be used on this machine model
ULT2001/ULT2002D/ULT2003D.
20°