Brother MFC-7820N - Manual (Page 36)

Chapter 2
2 - 3
General Setup
Setting the Mode Timer
The MFC has three temporary mode keys on
the control panel: Fax, Scan and Copy. You
can change the number of seconds or
minutes the MFC takes after the last Scan or
Copy operation before it returns to Fax mode.
If you select Off, the MFC stays in the mode
you used last.
1
Press Menu/Set, 1, 1.
2
Press
▲ or ▼ to select 0 Sec,
30 Secs , 1 Min, 2 Mins, 5 Mins or
Off .
Press Menu/Set.
3
Press Stop/Exit.
Setting the Paper Type
To get the best print quality, set the MFC for
the type of paper you are using.
1
Press Menu/Set, 1, 2.
2
Press
▲ or ▼ to select Plain, Thin,
Thick , Thicker, Transparency or
Recycled Paper .
Press Menu/Set.
3
Press Stop/Exit.
Note
■
The MFC ejects paper with printed
surfaces face down onto the output paper
tray in the front of the MFC. When you use
transparencies or labels, remove each
sheet immediately to prevent smudging or
paper jams.
■ You can select Transparency in Step 2
only if Letter, Legal or A4 paper size
was selected as the paper size
(Menu/Set, 1, 3).
General Setup
1.Mode Timer
General Setup
2.Paper Type