Quick print setup sleep time – Brother HL-7050N User Manual
Page 67
2 - 7 DRIVER AND SOFTWARE
HL7050_US_UG_FM5.5
Job Spooling
The printer saves data that you want reprinted.
You can reprint a document without sending the data again from your
PC (except for Secure Printing).
■
Last Job Reprint:
Reprint the last job
■
Secure Print:
Print the data with a password
■
Public:
Save the data without a password
■
Proof:
Save the data and print it
For more information about the Reprint function, see Reprint button
in Chapter 3.
Quick Print Setup
You can turn the Quick Print Setup function ON or OFF. A small
selection window appears on your computer, this will then let you
make changes to the settings of the following functions:
■
Multiple Page
■
Duplex
■
Toner Save Mode
■
Paper Source
■
Media Type
Sleep Time
When the printer does not receive data for a certain period of time
(timeout), it enters sleep mode. Sleep mode acts as though the
printer was turned off. The default timeout is 5 minutes and it is
automatically adjusted to the most suitable time-out setting
depending on the frequency of your printer use (Intelligent Sleep
Mode). While the printer is in sleep mode, the light on the display is
off, but the printer can still receive data from the computer. Receiving
a print file or document automatically wakes up the printer to start
printing. Pressing one of the buttons will also wake up the printer.
If you want to prevent other people from printing your data
using the Reprint function, clear the Use Reprint check box in
the job spooling settings.