Brother HL-7050N - Manual (Page 122)

CONTROL PANEL 3 - 38
HL7050_US_UG_FM5.5
List of factory settings
The following table shows the factory settings.
■ The emulation mode affects the setting. Effective modes
are shown in brackets in the following table.
■ The following settings cannot be restored to the factory
settings with the reset menu in the factory settings mode -
interface mode, HRC setting, page protection, scalable
font, lock panel, page counter and local language for
display messages.
■ The copy setting is always restored to the factory setting
when the printer is turned off and on again.
■ It is not possible to reset the network settings using the
control panel. If you want to reset the print server to its
factory settings (resetting all information such as the
password and IP address information), hold down the
Network Test button on the Network board (NC-4100h) for
more than 5 seconds.
Display Shows Submenu Factory setting
PAPER SOURCE =AUTO
PRIORITY =MP>T1>T2>T3>T4
MP FIRST =OFF
MP SIZE =ANY/A4/LETTER
MANUAL FEED =OFF
DUPLEX =OFF
OUTPUT =STANDARD
QUALITY RESOLUTION =600
HRC =MEDIUM
TONER SAVE =OFF
DENSITY 0
SETUP LANGUAGE =ENGLISH
PANEL CONTROL LOWER LCD=NONE
LCD DENSITY=1
AUTO ONLINE=ON
BUTTON REPEAT=0.1 SEC
MESSAGE SCROLL=LEVEL 1
POWER SAVE TIME =30MIN