Brother HL-7050N - Manual (Page 50)

ABOUT THIS PRINTER 1 - 31
HL7050_US_UG_FM5.5
Figure 1-22
4 Put the envelopes in the multi-purpose tray so they touch the
back of the tray and remain below the maximum paper mark
(
).
Figure 1-23
Envelopes that have been creased after they have been
printed:
At the back of the printer open the face-up output tray and
push down the blue tabs at the left-hand and right-hand sides
(as shown in the figure below). When you have finished
printing your envelopes, close the face-up output tray to reset
the blue tabs automatically. To reset the blue tabs manually,
push the blue tabs back to their original position.
Make sure that the paper is neatly stacked and in the proper
position on the multi-purpose tray. If it is not, the paper may
not be fed properly, resulting in a skewed printout or a paper
jam.
Up to ( )