Brother HL-2460 - Manual (Page 91)

3–6
When you use RAM to reprint:
☛ 1.
Press the Set switch on the control panel to exit from the READY status and
select RAM DISK SIZE in the SETUP mode.
☛ 2.
The default RAM is 0MB. Press the switch to increase the reprint RAM
size in increments of 1MB.
✒ Notes
When you increase the RAM size for secure printing, the work area of the
printer is decreased and the printer performance will be reduced. Ensure
that you reset the RAMSIZE to 0MB when you have finished using secure
printing.
When you store the data in RAM, the data will be deleted when the printer
power is turned off.
We also recommend adding additional RAM if you want to be able to print a
large amount of secure data. (
See “RAM Expansion” in Chapter 4 )