Brother HL-2460 - Manual (Page 197)

6–32
F F o o r r D D O O S S u u s s e e r r s s
P P P r r r o o o b b b l l l e e e m m m R R R e e e c c c o o o m m m m m m e e e n n n d d d a a a t t t i i i o o o n n n
Unable to print from
application software.
•
Check that the DOS application software interface settings match
that of your printer: for example, if you are using a parallel printer
cable, you would most likely set your DOS software printer port
to LPT1.
• Check if the printer has any printer alarms.
•
Check if the appropriate printer is selected in your application
software.
•
If the serial interface is used, make sure that the RS-232C serial
interface is selected with the slide switch. Make sure the
interface settings are correctly set up in INTERFACE mode using
the control panel. Make sure the serial parameters of baud rate,
parity and stop bits match between your application software and
the printer.