Brother DCP-J140W User Manual
Page 18
Configuring your machine for a wireless network
14
3
Connection when another device (C), such as a computer is used as a Registrar
.
1
The Registrar is a device that manages the wireless LAN.
Note
Routers or access points that support Wi-Fi Protected Setup have a symbol as shown below.
a
Press Menu.
b
Press a or b to choose 3.Network.
Press OK.
c
Press a or b to choose 4.WPS w/PIN Code.
Press OK.
d
If WLAN Enable? is displayed, press a for Yes to accept.
This will start the wireless setup wizard.
To cancel, press Stop/Exit.
e
The LCD will show an 8 digit PIN and the machine begins searching for a WLAN access point/router for
up to 5 minutes.
f
Using a computer that is on the network, type “http://access point’s IP address/” into your browser.
(Where “access point’s IP address” is the IP address of the device that is used as the Registrar
.) Go to
the WPS (Wi-Fi Protected Setup) settings page and input the PIN that the LCD displayed in step e to
the Registrar and follow the on-screen instructions.
1
The Registrar is normally the WLAN access point/router.
Note
The WPS settings page will be different, depending on the brand of WLAN access point/router. See the
instruction manual that came with your WLAN access point/router.
A
C