Brother DCP-J140W - Manual (Page 16)

Configuring your machine for a wireless network
12
3
One push configuration using Wi-Fi Protected Setup™ or
AOSS™
3
You can use WPS or AOSS™ from the control panel menu to configure your wireless network settings if your
WLAN access point/router (A) supports either Wi-Fi Protected Setup (PBC
1
) or AOSS™.
1 Push Button Configuration
Important
• If you are going to connect your Brother machine to your network, we recommend that you contact your
system administrator prior to installation. You must know your wireless network settings before you
proceed with this installation.
• If you have previously configured the wireless settings of the machine, you must reset the LAN settings
before you can configure the wireless settings again.
To reset the LAN settings, see Restoring the network settings to factory default uu page 26.
One-push configuration using WPS (Wi-Fi Protected Setup) or AOSS™
3
a Press Menu.
b Press a or b to choose 3.Network.
Press OK.
c Press a or b to choose 3.WPS/AOSS.
Press OK.
d If WLAN Enable? is displayed, press a for Yes to accept.
This will start the wireless setup wizard.
To cancel, press Stop/Exit.
e When the LCD shows Press Key on rtr, press the WPS or AOSS™ button on your wireless access
point/router. See the user's guide for your wireless access point/router for instructions.
Next, press a for Next. Your machine will now automatically detect which mode (WPS or AOSS™) your
wireless access point/router uses and try to connect to your wireless network.
A