Brother PT-9700PC - Manual (Page 31)

31
Printer control commands
ESC @ Initialize
[ASCII] ESC @
[Decimal] 27 64
[Hexadecimal] 1B 40
[Parameters] None
[Description]
・ Resets all parameters to their default settings. (See below.)
Item After Initialization
Command mode
(ESC/P, Raster or P-touch Template)
No change
Communication settings
(Baud rate, Parity, Bit length and Busy
control)
No change
Received text and bar codes Cleared
Received image data Cleared
Line feed amount AUTO
Relative position setting Cleared
Absolute position setting Cleared
Font Helsinki
Character size
AUTO
Italics OFF
Bold/double-strike printing
OFF
Underline OFF
Character
width Normal (Half-width and
double-width characters are
cancelled.)
Character code table Standard character code table
International character set USA
Frame None
Rotate OFF
Text alignment
Left
Margins 2 mm
Label length setting AUTO
Bar code protocol CODE39
Bar code width Small
Bar code ratio 3:1
Bar code check digit OFF
Characters below bar codes ON
Full cut ON
Half cut ON
Chain printing OFF