Timeguard EL17 - Manual (Page 3)

22
Figure 2 Figure 3
Installation – Panel Mounting
For panel mounting (in panels up to 7.0mm thick with the cut-out as shown in
figure 3) the EL11/17 should be snapped into the bezel supplied and secured
in place by the use of the 2 No. 6 x 3/8" self-tapping screws provided
as shown in figure 4.
When selecting a position for the unit it should be born in mind that a
clearance behind the front panel surface of 26.0mm is required over
the full area of the panel cut-out.
The unit is designed to be mounted from the front of the panel by the
following procedure:
a.
Insert the 2 bolts provided in the locations shown in figure 5.
b. Then insert the 2 No. 4 x 5/8 in self-tapping screws into the bolts
and engage thread.
c. Make connections to the unit by wires terminated in 1/4 in receptacles
from behind the panel. Ensure that the wiring is adequate for the load
to be carried.
d. Insert the EL11/17 complete with bezel into the panel and tighten up
the two No. 4 self-tapping screws. The ears on the bolts will rotate
under the tightening action to clamp the unit to the panel.
67mm
R 3.5mm
67mm