ROTRONIC MBW 973 - Manual (Page 12)

8 Getting Started
Selecting Units
The data may be viewed in any of the many available units. There are two Units menus used to
change the units of displayed data.
1. Use the lower right menu key to select the
Units menu. ‘Units’ appears on the key, and
the keys above contain current units
indications such as ‘Temp °C’. Notice that
each of the keys contain different types of
units. In this case, the keys do not correspond
to the adjacent data lines, but rather to
different units types.
2. To change temperature units, press the key
labeled ‘Temp’. Notice that the corresponding
units change each time the key is pressed.
Also notice that any data line that is currently
indicating temperature data also changes to
reflect the newly selected units.
3. Change other units (such as pressure, flow
rate, etc.) with the same method.
4. Note that there are two Units menus since
there are so many types of units that may be
changed. The second Units menu is obtained
by pressing the lower right menu key again.
5. If you like, you may clear the Units keys when
finished by cycling through all the menus using
the lower right key on the touch screen, or by
pressing the enter key once. Note that this is
not required and nothing is wrong with leaving
the Units menu (or any other menu) on the
screen.