Dwyer 8B User Manual
Page 5
MOUNTING METHOD
Step 1:
From the front of the panel, slide the controller housing through
the cut out. The housing gasket should be against the housing
flange before installing.
Step 2:
Insert the mounting brackets into the mounting grooves on the
top and bottom of the controller (16B, 8B, and 4B). For the 32B,
slide the mounting collar over the housing from the rear of the
panel.
Step 3:
Push the mounting brackets forward until the bracket stops at
the panel wall.
Step 4:
Insert and tighten the screws on the bracket to secure the
controller in place. (The screw torque should be 0.8 kgf-cm).
Mounting Bracket Installation
16B/4B/8B Mounting Method
32 Mounting Method
Page 5