Dwyer 8B - Manual (Page 3)

Page 3
MODEL NUMBER IDENTIFICATION
GETTING STARTED
1. Install the control as described on page 4.
2. Wire your control following the instructions on pages 6-7. Please read the
Precautions section located at the end of this manual before wiring the control.
3. For best results when programming changes are necessary, make all changes to the
Initial Setting mode (Pages 20-22) before making changes to the Regulation Mode
(Pages 17-19) or Operation Mode (Pages 15-16). If any error messages occur, check
the Diagnostic Error Message Section (Page 26) for assistance.
32B
OUTPUT 2
2 = Voltage Pulse
3 = Relay
OUTPUT 1
2 = Voltage Pulse
3 = Relay
5 = Current
6 = Linear Voltage
16B
OUTPUT 2
2 = Voltage Pulse
3 = Relay
OUTPUT 1
2 = Voltage Pulse
3 = Relay
5 = Current
6 = Linear Voltage
OPTIONS
OPTIONS
Blank = none
1 = Event input
2 = Current Transformer
-LV = Low Voltage
8B
OUTPUT 2
2 = Voltage Pulse
3 = Relay
OUTPUT 1
2 = Voltage Pulse
3 = Relay
5 = Current
6 = Linear Voltage
OPTIONS
OPTIONS
Blank = none
1 = Event input
2 = Current Transformer
-LV = Low Voltage
4B
OUTPUT 2
2 = Voltage Pulse
3 = Relay
OUTPUT 1
2 = Voltage Pulse
3 = Relay
5 = Current
6 = Linear Voltage
OPTIONS
OPTIONS
Blank = none
1 = Event input
2 = Current Transformer
-LV = Low Voltage
OPTIONS
OPTIONS
-LV = Low Voltage